This page summarises the Italian text of Legislative Decree 152/2006 (Annex I to Part Five, Part III, section 1.1), as amended by Legislative Decrees 183/2017 and 102/2020, up to date as of November 2026. It is for general guidance only: for a specific plant, the law in force and the plant permit apply, and the permit may set stricter values.
Which plants are covered
The tables on this page apply to combustion plants fired with solid biomass (wood chips, pellets, virgin wood residues, exhausted olive pomace and similar) with a rated thermal input of at least 1 MW and less than 50 MW: the so-called medium combustion plants, introduced in Italy by Legislative Decree 183/2017, which transposed the EU Directive 2015/2193.
The decree distinguishes two groups:
- existing plants: those put into operation before 20 December 2018, or permitted before 19 December 2017 and put into operation by 20 December 2018 (Article 268);
- new plants: all others.
From 50 MW upwards, plants are large combustion plants with different rules (Directive 2010/75/EU and BAT conclusions), which are not covered here.
NOx emission limit values
Values are in mg/Nm³ of nitrogen oxides expressed as NO₂, on dry flue gas at 6% oxygen. The guide value, explained in the next section, is shown in brackets.
| Rated thermal input | Existing plants | New plants |
|---|---|---|
| 1 to 5 MW | 650 mg/Nm³ (guide 450) | 500 mg/Nm³ (guide 300) |
| over 5 up to 20 MW | 600 mg/Nm³ (guide 300) | 300 mg/Nm³ |
| over 20 and below 50 MW | 450 mg/Nm³ (guide 300) | 300 mg/Nm³ |
Some details from the decree:
- for new plants above 5 MW, and for the guide values of existing plants above 5 MW, with a continuous emission monitoring system (CEMS) the value applies as a daily average; without one, as an hourly average;
- when poultry litter is burned, the limit is 200 mg/Nm³ at any size;
- below 1 MW specific tables apply: for example, 500 mg/Nm³ for new plants above 0.15 MW.
Areas with poor air quality
The guide values in brackets do not apply everywhere. The decree addresses them to the permitting authorities for sites located in areas where an air quality limit value (Legislative Decree 155/2010) was exceeded in at least one of the last three years. In those areas the permit limit can therefore drop, for example, from 600 to 300 mg/Nm³ for an existing 10 MW plant.
Italian regions can also set stricter values in their air quality plans. The limit that applies is always the one written in the plant permit.
Deadlines for existing plants
Article 273-bis of Legislative Decree 152/2006 gives existing plants a transition period:
| Plant | Limits apply from |
|---|---|
| Existing, above 5 MW | 1 January 2025 |
| Existing, up to 5 MW | 1 January 2030 |
| Biomass below 1 MW, installed before 19/12/2017 | 1 January 2030 |
In practice, an existing biomass boiler above 5 MW should already meet the new values. For 1–5 MW plants the deadline is 2030: it seems far away, but assessment, quotation, construction and commissioning of a DeNOx system take time, so it pays to start a few years early.
The ammonia limit
The decree also sets a value for ammonia: 7.5 mg/Nm³ at every size, for both existing and new plants. It applies when NOx is reduced with urea or ammonia, that is, with an SNCR or SCR system.
Part of the ammonia released by the urea does not react with NOx and leaves the stack with the flue gas: this is known as residual ammonia, or ammonia slip. That is why simply injecting more urea is not the answer: beyond a certain dosage NOx barely drops further, while stack ammonia rises. The control system automatically adjusts the urea flow based on the measured NOx, so that both limits are met.
What it means for SNCR users
An SNCR system typically reduces NOx by 30–60%, depending on the boiler, temperature and lance position. Some indicative examples:
- a boiler emitting 450 mg/Nm³ that must reach 300 needs a reduction of about one third: a typical SNCR case;
- going from 650 to 300 mg/Nm³ requires a reduction of more than 50%: this is at the upper end of SNCR performance and calls for a correctly configured system, with the lances in the right temperature window and well-tuned dosing;
- in every case the 7.5 mg/Nm³ ammonia limit still applies and constrains how much urea can be injected.
The starting point is always a measurement of current emissions and the limit in the permit. To see how a system works and how it is built, read the SNCR system guide; for a comparison with catalytic technology, the SNCR and SCR guide.
Summary
- Biomass boilers from 1 to 50 MW are “medium combustion plants” with specific NOx limits, at 6% O₂.
- For new plants the limit is 500 mg/Nm³ up to 5 MW and 300 mg/Nm³ above; for existing plants 650, 600 or 450 mg/Nm³ depending on size.
- Existing plants above 5 MW must comply from 2025, those up to 5 MW from 2030.
- In areas with air quality exceedances the permit may impose lower values, down to 300 mg/Nm³.
- With urea or ammonia, a stack ammonia limit of 7.5 mg/Nm³ also applies.
Frequently asked questions
What is the NOx limit for a new 1–5 MW biomass boiler in Italy?
500 mg/Nm³ of NOx, expressed as NO₂ at 6% oxygen. In areas where an air quality limit was exceeded, the permit may set a lower value, with a guide value of 300 mg/Nm³.
When must existing biomass plants meet the new limits?
From 1 January 2025 for plants above 5 MW and from 1 January 2030 for plants up to 5 MW, under Article 273-bis of Legislative Decree 152/2006.
Why is there an ammonia limit?
When NOx is reduced with urea or ammonia, as in SNCR and SCR systems, part of the reagent may leave the stack unreacted. The decree therefore sets an ammonia limit of 7.5 mg/Nm³.
Is an SNCR system enough to meet the limits?
Often yes: SNCR usually reduces NOx by 30–60%. The result depends on the starting emissions, the permit limit and the boiler, and on a correctly configured system: lances in the right temperature window and well-tuned dosing.
Sources
- Legislative Decree 152/2006 – Part Five, Articles 268, 271, 273-bis and Annex I (Normattiva, consolidated text, Italian)
- Legislative Decree 183/2017 – Italian transposition of Directive (EU) 2015/2193 (Normattiva, consolidated text)
- Legislative Decree 102/2020 – amendments to Legislative Decree 183/2017 (Normattiva)
- Article 273-bis of Legislative Decree 152/2006 – Medium combustion plants (Normattiva, Italian)
- Directive (EU) 2015/2193 on medium combustion plants (EUR-Lex)